Wednesday 27 May 2015

Install Dell 80 Gb Sata Hard Drive

Install 80 GB hard drive in a Dell computer.


There are several reasons to install a new hard drive in your Dell desktop or laptop. One of the most common reasons is the need for more space. Software, games and media files can fill up a smaller hard drive very quickly. This is why it may be necessary to upgrade your Dell computer's hard disk space to a 80 GB hard drive. Installation is not terribly complicated, but if not done correctly, you can permanently damage your newly purchased hard drive.


Instructions


Dell Laptop Hard Drive Installation


1. Turn off the laptop, disconnect the power cable and close the LCD display until it latches shut. Disconnect any other cables and external devices. Place the laptop face-down, and remove the battery pack.


2. Remove the two Phillips-head screws, securing the hard drive to the drive compartment. Slide the hard drive out of the compartment and set it to the side. Some models will have a plastic cover you must remove before gaining access to the hard drive compartment.


3. Slide the new hard drive into the drive compartment, and then replace the two retaining Phillips-head screws. Replace the plastic drive cover if necessary.


Dell Desktop Hard Drive Installation


4. Turn off the computer, disconnect the power cable and any miscellaneous cables or external devices.


5. Place the computer on its side, and then remove the two retaining Phillips-head screws, or (depending on the model) disengage the retaining tabs. Lift the side panel away from the computer to gain access to the hard drive compartment.


6. Disconnect the power and data cables from the rear of the hard drive. Remove the two Phillips-head screws securing the hard drive compartment in place. Remove the hard drive compartment. Remove the Phillips-head screws securing the hard drive inside of the drive compartment. Slide the hard drive out of the compartment.


7. Place the new hard drive inside the hard drive compartment so that the three securing screw holes on the drive are aligned with the screw holes on the drive compartment. Replace the drive compartment and screws in side the desktop. Connect the data and power cables to the rear connectors in the new hard drive.


8. Replace the side access panel and retaining screws. Place the computer tower vertically, and then reconnect the power cable and external devices. Turn on the desktop and test your new 80 GB hard drive.

Tags: drive compartment, hard drive, hard drive compartment, Phillips-head screws, compartment Slide, compartment Slide hard